Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Installation Instructions
Lamp Assembly (Fig. 1)
1.
Screw part (D1) onto part (F) then screw part (E1) into
part (D1).
2.
Screw part (D2) onto part (E1) then screw part (E2) into
part (D2).
3.
Screw part (D3) onto part (E2) then screw part (E3) into
part (D3).
4.
Screw part (D4) onto part (E3) then screw parts (A+B) into
part (D4).
5.
Screw parts (C x 2) into base of part (B).
Note: For best results locate your solar lamp facing the south.
Installation Instructions
Placing the Lamp on top of the Anchor
1.
Unscrew the two screws from part (F).
2.
Place the assembled lamp on top of the Auger stake.
3.
Secure part (F) to part (G) using the two screws.
Replacing the Batteries
After several years of use, the battery may need
replacing.
1.
Unscrew the two screw caps and detach part (A) from part
(B). Make sure the ON/OFF switch is in the OFF(O) position.
2.
Unscrew the battery compartments' screws (Fig. 2) located
on the silver reflector and remove the two compartment
doors.
3.
Unclip the connector and remove both old batteries. Make
sure the two new batteries are high quality 3.2V/1,500mAh
Li-ion Rechargeable batteries with connector.
4.
Clip on new batteries and install into the battery
compartments. Screw back battery compartments' screws.
5.
Turn the operation switch back to ON (|) position.
6.
Reattach part (A) to part (B) and secure with the 2 screw
caps.
Publicité
