Miele SEB 213 Instructions Pour L'utilisation page 25

Replacing the roller brush drive belt
The Powerbrush housing must be
opened in order to replace the drive
belt.
^ Remove the roller cover a by loosen-
ing the two lock screws on the bot-
tom of the Powerbrush using a coin
or screwdriver. Remove the roller
cover.
^ Pull up the roller brush b until it re-
leases from the main housing, and
slide the drive belt over the end of
the brush. Set the roller brush aside.
^ Remove the 4 screws c in the lower
housing of the Powerbrush d, then
separate the lower housing from the
upper housing e.
^ Install a new drive belt by slipping it
over the gear on the motor shaft and
the toothed side of the roller brush.
^ Reassemble the Powerbrush by re-
versing the procedure.
All manuals and user guides at all-guides.com
SEB 213 / SEB 217 Maintenance and Care
25