AmazonBasics B07H34TYDV Mode D'emploi page 8

• Slide the hoses (P,Q) and screw bolts (L) through the hole in the basin.
• Slide the c-shaped rubber washer (M) and c-shaped metal washer (N) over the screw bolts (L).
• Screw the threaded nuts (O) onto the screws bolts (L).
NOTICE
Installation
Step 4:
Connect the water supply lines
• Screw the faucet supply line with the red marking (P) to the hot water supply inlet and screw the
supply line with the blue marking (Q) to the cold water supply inlet.
• Securely tighten with a wrench.
NOTICE
8
Make sure the faucet is centred over the basin hole before you finish tightening
the threaded nuts (O) with a wrench.
Hot supply hose
If you are replacing the old water supply lines, make sure you clean the threads
on both water inlet valves. Use a wrench to tighten down the fittings and follow
the steps above to connect the water lines to the faucet.
Cold supply hose