Publicité
Les langues disponibles
Les langues disponibles
• Slide the threaded drain tube (C) with rubber washer (D) through the top of the hole at the
bottom of the basin.
• Put the rubber gasket (E) onto the pop-up body and make sure the taper side of the rubber
gasket faces upward, towards the basin hole.
• Hold and position the pop-up body (F) at the bottom centre of the basin hole.
• Screw the threaded drain tube (C) into the pop-up body (F).
NOTICE
Installation
Step 7:
Install the stopper
Remove protective cover from the top of the stopper and insert stopper into the threaded drain tube.
10
When finished tightening down the drain tube into the pop-up body, make sure
the pivot hole is facing towards the back of the basin.
Stopper
Rubber washer
Rubber gasket
Pop-up body
Make sure the pivot washer is in the pop up body tube.
Joint nut and screw
Pivot hole
Pivot nut
Pivot rod
Publicité
