shark Freestyle Slim Manuel D'utilisation

SLIM SHARK
S3 S1 S2
S1 – Mode Button
S2 – Set Button
S3 – Light Button
DISPLAY MODES:
The watch has three display
modes:TIME, CALENDAR and SEC-
ONDS.
To change from one display mode to
another, press S1 button once.
NOTE: In CALENDAR mode, the watch
will automatically return to TIME mode
if there is no buttons pressed for ap-
proximately 3 seconds.
TO SET THE TIME AND CALENDAR:
1. Press S1 button to select TIME
mode.
2. Press S2 button twice, the month
digits will be displayed.
3. Press S1 button to set the month
digits. Holding down the button will
speed up the process.
4. Press S2 button, the date digits will
be displayed.
5. Press S1 button to set the date
digits.
6. Press S2 button, the hour digits will
be displayed.
7. Press S1 button to set the hour
digits.The hour digits are displayed
in the 12-hour format, then in the
24-hour format and then again
in the 12-hour format. Therefore,
please press S1 button so many
times that the hour digits are
displayed in the required format. In
the 12-hour format, the hour digits
are identified by "A" for 12:00 A.M.
– 11:59 A.M. and by "P" for 12:00
P.M. – 11:59 P.M.; whereas in the
24-hour format, the hour digits are
identified by "H".
8. Press S2 button, colon and the
minute digits will be displayed.
9. Press S1 button to set the minute
digits.
10. Press S2 button, the hour digits,
colon and the minute digits will be
displayed.
11. When finished making all the set-
tings, press S1 button to confirm.
The colon will blink.
TO SET THE SECONDS:
1. Press S1 button to select SECONDS
mode.
2. Press S2 button to reset the second
digits to zero.
TO USE THE BACKLIGHT:
Press S3 button to turn on the back-
light for approximately 3 seconds.
ENGLISH
To reduce carbon foot print, these
SHARK instructions are printed with
soy inks on recycled paper.