Publicité
Les langues disponibles
Les langues disponibles
WARMING RACK AND COOKING GRATE
1. Install the Warming Rack and Cooking Grate as shown in Fig 8.
Fig. 8
CLEAN-OUT PORT KNOB
1. Clean-out Port knob must be pushed in when grill is on. Make
sure pullout lock is pushed down and locks the knob to prevent
inadvertent opening of the clean-out port. See Fig 9.
2. Lift pullout lock and pull clean-out port knob to empty ash into
ash cup. See Fig 10
3. See instructions for burner clean-out.
Fig. 9
Fig. 10
Page 6
All manuals and user guides at all-guides.com
WARMING RACK
COOKING GRATE
WARMING RACK
COOKING GRATE
CLEANOUT PORT KNOB
CLEANOUT PORT KNOB
PROBE
1. Plug the Meat Probe into the Probe receptacle on the control
panel. Run the probe and wire through the probe access hole on
the side of the grill. See Fig 11.
2. See instructions for Meat Probe.
Fig. 11
BURNER CLEAN-OUT
Before each use the burner should be cleaned out by lifting the
pullout lock and pulling the clean-out port knob on the right side
of the grill to open the burner clean-out. This will allow the ash
from previous use to fall into the cup under the grill. The cup
should be removed and emptied and then reinstalled before
each use.
Never Operate the Pellet grill without the
ash cup in place.
Make sure the burner clean-out port is
closed and locked before starting the grill.
Never open the burner clean-out port when
the grill is hot.
After cleaning out the burner make sure to close the burner
clean-out by pushing the clean-out port knob in on the right side
of the grill. Make sure to lift the pullout lock and push the
clean-out port knob all the way in and lock in place with the
pullout lock. Every 50 hours of use, remove the grill grates, grease
WARMING RACK
PROBE HOLE
PROBE
DANGER
CLEANOUT PORT KNOB
COOKING G
CLEANOUT
Publicité
