Lincoln 615 Manuel D'instructions

Capacity - 18 oz. (533 cubic cm)
©
DO NOT USE WITH GASOLINE OR DIESEL FUEL.
ASSEMBLY
Attach the nylon hose© to the end of the suction gun. The
threads do not require much tightening to seal. Slide the flex-
ible tube onto the hose fitting.
A light coating of motor oil may be used as a lubricant if the
joint is extremely tight.
OPERATION
The Suction gun operates simply by pulling back on the handle
to remove fluids and pushing down on the handle to add or top
off a fluid.
Fluids that are difficult to extract cold will extract easier when
warmed up slightly by operating the vehicle.
The suction gun can be filled and used to add oil to gear boxes
where the filler hole has poor accessibility. Whenever adding
fluids make sure the gun is cleaned out before filling with clean
oil.
© Indicates change
OCT - 2011
SERVICE PARTS
Part Qty Description
274780 1 T-Handle
274781 1 Nut
274782 1 Support Washer
274783 1 Rubber Plunger
One Lincoln Way
St. Louis, MO 63120-1578
Phone +1.314.679.4200
Fax +1.800.424.5359
Form 404361
Part Qty Description
274784 1 Nyloc Nut
274785 1 Rubber Washer
274786 1 Front Cap
274787 1 Flexible Tube
MAINTENANCE
The rubber packing on the suction piston and the tube cap
rubber gasket are oil resistant but may swell and become soft
if used with some non-lubricating fluids. It is recommended
that these rubber parts be cleaned and wiped dry after con-
tacting non-petroleum or questionable fluids.
Americas:
USA
Section
SUCTION GUN
Model 615
Series "D"
Copyright 2011
Printed in India
Web site:
www.lincolnindustrial.com
- D15 - 1E
Page