Fortin CAN-SL2 Manuel D'instructions page 2

Connector 1 (Black - 4 pins):
Determin the type of installation:
INSTALLATION
1
DATA-LINK
INSTALLATION
WITHOUT
DATA-LINK
LED
Cut off one plug of the Data-Link connector, connect the red wire to +12V and the black wire to ground.
Front view of the module
Connect wire to Remote-Starter/Alarm
Copyright © 2008, FORTIN AUTO RADIO INC ALL RIGHTS RESERVED
CHEVROLET Impala
Red
conn. Data-Link connector
Black
WITH
Blue
White
Red +12V
Black Ground
Blue
White
Connect wire to vehicle
Technical support:
TEL: 514-255-HELP (4357)
FAX: 514-255-1367
Web: www.ifar.ca
2006-2009
1
Starter or alarm
Port Data Link
INPUT
OUTPUT
Neither the manufacturer or distributor of this module is
responsible of damages of any kind indirectly or directly
caused by this module, except for the replacement of this
module in case of manufacturing defects. This module must
be install by qualified technician. This instruction guide may
change without notice. Visit www.ifar.ca to get latest version.
CAN-SL2
WEB
UPDATE Made in Canada - Rev. A - 01 / 02 / 2009
W e b s i t e : h t t p : / / w w w . i f a r . c a
ALARM AND REMOTE STARTER CAN BUS INTERFACE KIT
Make the connections of the CAN-SL2 to the
vehicle:
1
1.A
Connector 1 (Black):
Determine the type of installation:
INSTALLATION WITH DATA-LINK
INSTALLATION WITHOUT DATA-LINK
1.B
Connector 2 (White):
Make the connections
1.C
Connector 3 (White, located at the back of the module):
Make the connections
Press the programming switch while
inserting the main wires harness (
into the CAN-SL2 module.
The LED will illuminate to indicate you are
2
in programming mode, release the
programming button.
Connect
( CONN. 2
WARNING: Connector 2 can be easily
3
plugged in backwards.
Connect
( CONN. 3
4
5
Turn the key to the
Once the LED starts to flash rapidly
the key to the
6
The LED will turn off to indicate the
module has been programmed.
The module is now ready for use.
CONN 1 )
the other connectors
)
the other connectors
)
"ON" position .
turn
OFF position .