3.
4.
5.
6.
Refer to device manual for wiring details. Module provides
terminals for Zone input, and Positive/Common for power.
2 / 20
Power is taken from BUS power, refer to main panel
manual for current limitations for the relevant standard.
(1)
EOL
7.
Put a jumper across TERM on the first and last device on
a cable run to ensure correct RS-485 termination and
avoid communication issues with signal reflection, etc.
8.
9.
Firmware
Upgradeable using DLX900 over network or with a USBUP
and the USBUP port.
(1)
(2)
(2)
Power for zone
1..2..3...
P/N 230255-ML • REV F • ISS 16MAR21