Publicité
Les langues disponibles
Les langues disponibles
2.
Installation position in wet rooms
A 30mA residual-current circuit breaker is mandatory for installation in wet rooms.
The infrared heater may only be installed in safety zones 2 and 3 (see illustration).
During installation, ensure that the
infrared heater or infrared towel rail
cannot be operated or controlled from
the bath or shower position. The
thermostats must therefore be installed
so that they cannot be reached from the
bath or shower.
3.
Control
If the devices are not fitted with an
integrated control system, the regulation
must be provided by an external
thermostat controller that complies with
the Ecodesign Directive.
4.
Cleaning
Do not use any abrasive or aggressive cleaning agents to clean the infrared heater or
infrared heated towel rail. We recommended cleaning with window cleaner or soapy water.
CAUTION:
The infrared heater must have cooled down fully before cleaning.
(Risk of damage due to cold shock)
5.
Faults
The device does not heat up:
Please check the power supply.
If the device does not heat up but the power supply is in working order:
Please send the device to your HEATSCOPE
Faulty or damaged power cable:
Faulty power cables must be replaced by the device manufacturer.
CAUTION:
If the glass panel is damaged, stop using the heater and immediately disconnect it
from the power.
A M B I E N T H E A T I N G S O L U T I O N S
2.25 m
2
3
dealer for inspection.
®
1
EN
9
Publicité
