Publicité
Les langues disponibles
Les langues disponibles
FOR INSTALLATION WITH M5
HEAD AND CENTER SECTION
1.
The M5 ISR Leg comes ready to install.
Determine which center section mounting holes to use to ensure a minimum of 6" clearance between the truck bed rail and
2.
the bottom of the trailer. ( For more detail, please refer to the GUIDELINES FOR MATCHING HITCH, TRUCK, AND
TRAILER section located in the head and center section instruction sheet.) Legs should be attached at same height on
both sides of unit. This unit has 4" of vertical adjustment.
Using (4) of the M16x2x40 mm Hex Head Bolts with (4) 5/8" Conical Washers, attach the legs to the center section
3.
structure, threading the bolts from the inside of the center section into the threaded portion of the legs. Place the remaining
(2) M16x2x40 mm Hex Head Bolts in the center hole location on both legs using (2) of the 5/8" conical washers and the (2)
M16x2 Nuts. Finger tighten bolts initially until final adjustments are made.
©
2018 Horizon Global America Inc.
Product Instructions
M5 ISR 27K LEGS
ASSEMBLY AND INSTALLATION
Page 2 of 21
06/21/2022
30927N
09/25/2018
Part Number:
30927
Rev. B
Rev. A
Publicité
