Snooze Function; Sleep Timer Operation; Setting Sleep Timer - JVC RA-F230W Manuel D'instructions

To turn off the alarm
, press POWER and the alarm will come on again at the set
time on the following days.
To cancel the alarm,
repeatedly press AL1 / AL2 until the alarm indicator light
goes out on the display.

SNOOZE FUNCTION

This function can be used to stop the alarm temporarily for about 9 minutes once
the alarm is activated. When you press SNOOZE, the buzzer or radio alarm sounds
will stop and sound again after about 9 minutes.

SLEEP TIMER OPERATION

The sleep function is designed to automatically turn off the Radio.

SETTING SLEEP TIMER

1. Press SLEEP.
• "90" will illuminate on the display.
2. Repeatedly press SLEEP to select the desired sleep time from 90, 80, 70, 60, 50,
40, 30, 20 or 10 minutes.
3. The radio will be turned off after the selected time has elapsed.
To check remaining sleep time, press SLEEP.
To cancel sleep timer, press SLEEP until "OFF" is selected.
To turn off the radio before the sleep time has elapsed, press
POWER.
PROJECTOR
With this projection function, you can conveniently project the clock time onto a
surface e.g. walls.
 To turn on or off the projection, press PROJECTOR ON/OFF.
 To focus the projected time, rotate the projector wheel.
 To change the projection to a desired angle, rotate the projector.
NOTE:
When turning on the projector, consideration has to be made to prevent the
projection lens being looked into.
Looking into the projection lens is dazzling and could cause damage to your
eyes. Do not stare directly at the projection lens.
The maximum projection distance is 2 metres.
EN-5