Battery Backup; Standby Mode; Radio Operation - JVC RA-F230W Manuel D'instructions

3. VOLUME
4. VOLUME
5. FM aerial
6. TUNING
7. TUNING
8. SLEEP button
9. SET button
10. SNOOZE / DIMMER button
11. BAND button

BATTERY BACKUP

The clock, alarm and preset stations settings can be protected against AC power failure
with the batteries for a short period of time. If no backup batteries are installed or the
power failure is prolonged, you will need to set the clock again.

STANDBY MODE

Place the unit on a flat stable surface and plug the power cord into the mains
socket.
 The unit is in standby mode and "0:00" will flash on the display.
SETTING THE CLOCK
In standby mode, press and hold SET until the display flashes.
1.
Whilst the display is flashing, repeatedly press HR and MIN respectively until
2.
the desired clock time appears.
 Press and hold HR and MIN respectively for fast advance.
Press SET to confirm.
3.
 The hour and minute digits will stop flashing.
POWER ON/RADIO MODE
Press POWER to switch the unit on and enters the radio mode.
The radio frequency will briefly appear on the display and then return to clock

time.

RADIO OPERATION

Press POWER to turn on the radio.
1.
The default FM frequency or the last frequency

you tune the radio to.
The default FM radio frequency is 87.5 MHz.

/ AL2 button
/ AL1 button
/ HR button
/ MIN button
12. MEM button
13. Battery cover (at the bottom)
14. PROJECTOR ON/OFF button
15. Projector wheel
16. Projector
17. Alarm 1 buzzer indicator
18. Alarm 1 radio indicator
19. Alarm 2 buzzer indicator
20. Alarm 2 radio indicator
EN-3