Monster FlatScreen SmartView 300M Guide D'utilisateur page 16

Attaching the Tilting Vertical Adjustment Bars to the TV
DO NOT lay your TV face down when attaching the Tilting Vertical
Adjustment Bars. This can cause permanent damage to your
screen. Lean it against a wall or other solid surface so it remains
vertically upright.
Your TV should be unplugged before threading any bolt or screw
into the back panel.
Your mounting system features 12 sets of screws of varying diameter and
length. Before attaching the adjustment bars to your display, determine which
screw set is correct for your display.
TVs with fl at backs use a shorter screw without a spacer. TVs with curved backs
or recessed inserts may require a longer screw with a spacer between the TV
and adjustment bars. Smaller M4, M5 or M6 screws require a square washer
(supplied) between the adjustment bar and each screw.
1)
Locate the threaded inserts on your TV's back panel. Thread a screw
from the set into one of the inserts to ensure it is the correct choice.
2) Thread screws through the adjustment bars into the TV inserts with the
appropriate spacer and washer set, if needed. Make sure to install each
adjustment bar so its Pull 'n' Twist
3) With a Phillips screwdriver, tighten the screws so the adjustment bars
are fi rmly attached to the TV.
DO NOT over tighten screws. Thread screws carefully by hand before
tightening. If you feel any resistance, remove the screw immediately.
12
Pull 'n' Twist handle faces the outer edge of the TV. Pull 'n' Twist
™ ™