Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8844110
IDENTIFICATION KEY
A
Pad Clip, Front
B
Knob handle
C
Sanding Pad
D
Handle
E
Trigger
F
Air Inlet
G
Pad Clip, Rear
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
INSTALL AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (sold separately) for use with
your tool.
1.
Wrap the external threads of the coupler plug with sealant tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2.
Screw the coupler plug into the tool's air inlet and tighten with a
wrench until snug.
3.
Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is connected directly
to the air tool. To overcome this, connect a leader hose to the tool. A quick
coupler may then be used to connect the leader hose to the air line hose.
FIT THE SANDING SHEET
1.
Disconnect the tool from the air source.
2.
Select abrasive paper of the correct grit for the task.
3.
Raise the front and rear pad clips (A and H) to release the sandpaper
holders.
4.
Insert the abrasive paper into the front clip. Close the clip, trapping the
paper.
8
2-3/4 x 17-1/2 in. Straight Line Air Sander
For technical questions call 1-800-665-8685
V1.0
Fig. 1
Publicité
Table des Matières
