Porter Cable PCCW201 Manuel D'instructions page 11

Installing and Removing the Battery Pack
(Fig. E, F)

CAUTION: Always depress the on/off switch
"O" position before installing the battery pack. The
sander will turn on if left in the on ("I") position when
the battery is installed.
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 7 into the tool handle, align the
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 8 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. E
Fig. F
8
Proper Hand Position (Fig. G)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden reaction.
Proper hand position requires one hand on the back handle
2 and one hand on the front handle
Figure G.
All manuals and user guides at all-guides.com
Fig. G
1 at the
On/Off Switch (Fig. A)
•
•
Variable Speed Dial (Fig. A)
To operate the tool, select the speed setting you wish with
the speed dial
7
switch. The speed setting can be adjusted either with the
tool ON or OFF.

Be sure to select the proper speed for your sanding
operation. If in doubt about the proper speed for your
operation, test the performance at low speed settings and
gradually increase until a comfortable speed is found.
Operation

Grasp the sander and turn it ON. Move it in long, sweeping
strokes along the surface, letting it do the work. Pushing
down on the tool while sanding actually slows the removal
rate and produces an inferior quality finish.
Check your work often. This sander is capable of removing
material rapidly.
Dust Collection (Fig. H, I)

3 as shown in
•
•
•
To switch the tool on, depress the on/off switch
the "I" position.
To switch the tool off, depress the on/off switch
the"O" position.
9 , shown in Figure A, and press the ON/OFF
CAUTION: Because the PCCW201 has a separate
speed dial for setting the speed (8,000 - 18,000 OPM),
the tool will start at the speed where the variable
speed dial is set. Always depress the on/off switch
at the "O" position before installing the battery pack.
WARNING: Let the tool work at its own pace. Do
not overload.
WARNING: Collected sanding dust from sanding
surface coatings (polyurethane, linseed oil, etc.)
can selfignite in sander dust bag or elsewhere
and cause fire. To reduce risk, empty bag frequently
and strictly follow sander manual and coating
manufacturer's instructions.
The dust bag should be emptied after every 10 minutes
of sanding.
To attach the dust bag to the sander, line up the
grooves on the side dust bag collar
15
dust bag locks on the dust port
17
Slide the dust bag onto the dust port and turn the dust
bag clockwise to lock it in place as shown in the insert
of Figure H.
English
1 at
at
1
1
with the
16
.
18
9