Publicité
Les langues disponibles
Les langues disponibles
LBSE-EM – LiteBox® Edge-Lit EM Battery Pack Accessory
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Follow label information and instructions concerning Wet or Damp Locations, installation near combustible
materials, insulation, building materials, and proper lamping. Do not install in areas subject to combustible
vapors or gases. Before wiring to power supply and during servicing or relamping, turn off power at fuse or circuit
breaker. All servicing or relamping must be performed by qualified service personnel. Product must be
grounded to avoid potential electric shock or other potential hazard. Product must be mounted in
locations and at heights and in a manner consistent with its intended use, and in compliance with the
National Electrical Code and local codes. The use of accessory equipment not recommended by the
manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating
from product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes,
curtains, screens or the like to come into contact with the product or to block light from the product, as this may
cause an unsafe condition.
EM Accessory Compatibility
LBSE EM accessories are compatible only with corresponding
Prescolite LiteBox Edge-Lit Remote J-Box Mount Downlights
below. Use maximum mounting height shown to comply with UL
924 minimum foot-candle requirements.
EM Catalog No.
LBSE-4RD-EM
LBSE(S)-4RD-xxxx-RM-WH
LBSE-6RD-EM
LBSE(S)-6RD-xxxx-RM-WH
LBSE-8RD-EM
LBSE(S)-8RD-xxxx-RM-WH
LBSE-4SQD-EM
LBSE(S)-4SQD-xxxx-RM-WH
LBSE-6SQD-EM
LBSE(S)-6SQD-xxxx-RM-WH
LBSE-8SQD-EM
LBSE(S)-8SQD-xxxx-RM-WH
Replacement Battery for all EM models:
Use only Prescolite Replacement Battery Item LBSE-EM-BAT
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
For use only with:
© 2022 HLI Solutions, Inc. All rights reserved.
Max.
Mounting Height
9 feet (2.7m)
currentlighting.com/Prescolite
Technical Support: 888.777.4832
LBSE-6RD-EM shown for reference only
Part No. ....93131014
Rev A
Page 1 of 8
Publicité
Table des Matières
Sommaire des Matières pour Current Prescolite LiteBox LBSE-EM Serie
- Page 1 INSTALLATION INSTRUCTIONS LBSE-EM – LiteBox® Edge-Lit EM Battery Pack Accessory IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do not install in areas subject to combustible vapors or gases.
-
Page 2: Installation Instructions
INSTALLATION INSTRUCTIONS LBSE-EM – LiteBox® Edge-Lit EM Battery Pack Accessory Connect the male plug from the Driver Box to the female Drill a 3.50” hole using a hole saw. plug from the Inverter Box. Connect the Driver Box to the Inverter Box using the Pass wiring from Inverter Box through conduit into Driver Box. - Page 3 INSTALLATION INSTRUCTIONS LBSE-EM – LiteBox® Edge-Lit EM Battery Pack Accessory If using a color trim ring accessory: Snap it onto the fixture Snap EM Trim Ring into the back of the fixture as shown. before attaching the EM Trim Ring. Also remove and discard the white spacer insert behind the EM test switch panel.
-
Page 4: Operation And Maintenance
INSTALLATION INSTRUCTIONS LBSE-EM – LiteBox® Edge-Lit EM Battery Pack Accessory Operation and Maintenance Test Button Functions 1. While main power is on: Press test button for <3 seconds to simulate “line power outage” or emergency mode”. The light fixture will come on using battery power. Press test button for 3-6 seconds to initiate a brief self-check test routine (approx. -
Page 5: Lbse-Em - Accessoire Pour Bloc-Batterie Litebox® Edge-Lit Em
INSTRUCTIONS D’INSTALLATION POUR LBSE-EM - Accessoire pour bloc-batterie LiteBox® Edge-Lit EM BSE/LBSES-RM – LiteBox® Edge-Lit Support de J-Box à distance IMPORTANTES INFORMATIONS SUR LA SÉCURITÉ. LISEZ ET RESPECTEZ TOUTES LES CONSIGNES DE SÉCURITÉ. Lisez les informations et suivez les consignes sur l'étiquette relativement aux emplacements mouillés ou humides, à l'installation à... - Page 6 INSTRUCTIONS D’INSTALLATION POUR LBSE-EM - Accessoire pour bloc-batterie LiteBox® Edge-Lit EM Connectez la fiche mâle du Driver Box à la fiche femelle Percer un trou de 3,50 po à l'aide d'une scie cloche. du Inverter Box. Faites passer le câblage du boîtier de l'onduleur à travers le conduit Connectez le boîtier de commande au boîtier de l'onduleur à...
- Page 7 INSTRUCTIONS D’INSTALLATION POUR LBSE-EM - Accessoire pour bloc-batterie LiteBox® Edge-Lit EM Si vous utilisez un accessoire de bague de finition de couleur: Enclenchez l'anneau de garniture EM à l'arrière de fixez-le sur le luminaire avant de fixer la bague de finition EM. l'appareil comme indiqué.
-
Page 8: Opération Et Maintenance
INSTRUCTIONS D’INSTALLATION POUR LBSE-EM - Accessoire pour bloc-batterie LiteBox® Edge-Lit EM Opération et maintenance Fonctions du bouton de test 1. Lorsque l'alimentation principale est activée: Appuyez sur le bouton de test pendant <3 secondes pour simuler une «panne de courant» ou un mode d'urgence ».