Sillicone Gasket Installation - cosori C2126-PC Manuel D'instructions

• Thoroughly wash and rinse all parts of the lid including the pressure release valve,
anti-clog filter, and float valve. Wipe dry with a clean cloth.
• All parts inside the lid can be hand washed separately with water and should always be
checked to make sure they are not damaged or cracked.
• The silicone gasket can be removed from the lid. Wash the gasket with liquid
detergent and warm water, and dry it with a clean cloth. (Refer to the Silicone Gasket
Installation section on how to remove and install the gasket.)
• Use a sponge or non-metallic soft brush to clean the inner pot, then wipe the surface
with a clean cloth.
Silicone Gasket Installation
NOTE: Make sure the silicone gasket is not cracked or damaged in any way.
Removal
1. While holding the lid in place, gently pull out the silicone gasket.
Installation
1. Line up silicone gasket on top of metal ring.
2. Gently push down on silicone gasket, ensuring that the metal ring is inside the
gasket's groove as shown above. Continue pushing the silicone gasket all around
until it is secured by the metal ring.
3. Place lid back onto pressure cooker.
15