Hubbell CFB10FFDIVKIT Instructions D'installation

CFB10FFDIVKIT FURNITURE FEED DIVIDER KIT
10 GANG RECESSED CONCRETE FLOOR BOX
CAUTION: RISK OF ELECTRICAL SHOCK. Disconnect power before installing or servicing.
NOTICE: For installation by a qualified electrician in accordance with all national and local electrical codes,
communications standards, the following instructions and any instructions included with individual devices.
NOTICE: Ensure data/communications circuits are separated from lighting/power circuits in accordance with the NEC
and CE Code requirements.
Use with CFB10G55 series floor boxes and 610GCFFCVR or 610GTFFCVR series covers.
See 610GCFFCVR and 610GTFFCVR series cover installation instructions to install cover.
1.
Remove temporary concrete cover, pull and dress wires
as per 610GCFFCVR and 610GTFFCVR series cover installation instructions.
2.
Retain cover partition components [7] for installation to cover. Refer
to 610GCFFCVR and 610GTFFCVR series cover installation instructions.
3.
For multi service applications, wireway [1] and spacer plates [2] must
be removed, see FIGURE A. Place wireway [1] and spacer plates [2] in
low voltage chamber for use in future applications. Reinstall
wireway [1] screw. Spacer plate [2] screws may be installed
in an unused threaded hole.
4.
For multi service applications, dividers [3] can be removed
as needed, see FIGURE A.
1 INCH FEED WIRING CHAMBER
2 INCH FEED WIRING CHAMBER
Wiring Device - Kellems
Hubbell Incorporated (Delaware)
Shelton, CT 06484
1-800-288-6000
www.hubbell-wiring.com
PD2930
02/21
Installation Instructions
2
1
2
3
3
7
ENGLISH
3 3
FIGURE A