Publicité
Les langues disponibles
Les langues disponibles
FUS72 ONE
Caution:
i
Meaning of the LED (3)
- If the LED flickers fast (3x/sec.), the battery is discharged: please use a new battery.
- If the LED flickers slowly (1x/sec.), the resetting is in progress.
- If the LED is continuously on, the resetting is complete and the motor is powered.
i
If the actuator detects voltage on the power cable, a brief contact of the battery is enough to start the resetting process.
i
The power supply of this actuator cannot be individually replaced. If the cable is damaged, the
whole unit must be discarded and replaced.
i
The housing of the mechanism contains a temperature sensor. When the temperature in the housing exceeds 72°C, the
mechanism unlocks. The LED flashes twice per second. When the temperature drops below 72°C, the mechanism can
only be reset in a motorised manner after a manual reset (with a battery).
i
The end of range switches need 1 second after operation to adopt a stable position.
i
Make sure the thermal trigger device is present in the actuator. The actuator might not function properly if this is not
the case.
d
ismantling
1. Open the battery
compartment.
m
ounting
If the product is manipulated in any other way than described in this manual, Rf-Technologies
will decline any responsibility and the guarantee will immediately expire!
Fusible link 72°C
3
2
2. Press the flexible button
inside the battery
compartment.
3. Pull simultaneously
the fusible link and the
rubber cover out of the
mechanism.
4. Insert the new fusible
link and its cover in
the mechanism until
it clicks in place.
Close the cover of the
battery compartment
hermetically.
Caution:
i
Make sure that dust
and moist can't enter
the housing of the ONE
while replacing the
fusible link.
K131-C
04/2021
7
Publicité
