Antari SW-250 Mode D'emploi page 9

DMX Connector Pin Assignment
The machine provide 3 pin XLR connector for DMX connection. Diagram below indicate pin assignment
information
DMX CONTROL OPERATION
SW-250 has on-board DMX control and the addressing is via LCD control panel. SW-250 uses 1 channel to
control output on/off and volume. The channel has a value range from 0 to 255. The on/off function can also
be programmed with a DMX controller or DMX control software used by lighting and effects operator.
Channel A
11-255 = ON (1%-100%)
0-10 = OFF
If the value of channel A is set between 0 to 10, the unit is off.
While the value is set between 11 to 255, the unit is on.
Note: Once DMX cable is connected to the unit, then the LCD control panel, W-1 transmitter and HC-1
controller connected cannot be used.
MAINTENANCE
1. Do not allow the snow liquid to become contaminated. Always replace the caps on the liquid container
and the snow machine liquid tank immediately after filling.
2. Before storing away after each operation, rinse the system with pure water and let it pump for at least
1or 2 minutes. This step helps to ensure a longer life-span of the motor and the nozzle.
3. It is strongly recommended to regularly clean the dust/residue around snow machines' vent holes (on
both sides of the machine). Simply use a small brush, a toothbrush for example, and gently brush in the
direction from top to bottom. This step helps to ensure that minimal debris will get into the machine or
Pin
1
2
3
Function
Ground
Data-
Data+
9