Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User Manual KSK-3210 RF
3.3 Keyboard installation
•
Recommended requirement is the successful installation of the USB receiver under point 3.2
•
If you haven't done yet, remove the covering of the battery case on the bottom of your keyboard. Install
the included batteries of type AAA 1.5 V considering the right polarity in the battery case (see picture).
•
The USB receiver and the keyboard are factory-made already synchronised on the same channel. Nor-
mally you have not to make a new-synchronisation (as described under point 3.4).
•
Now you can check this by pressing any key of your keyboard.
If you press the Windows key, for instance, the Windows Pop-up
menu down left on your screen has to open. If so, your
wireless keyboard is working correctly now. If not, please
synchronise the USB receiver and the keyboard again like
described under point 3.4.
Advise: Should the functionality be infl uenced by other users
applying their wireless keyboard close-by, make a new-
synchronisation as described under point 3.4.
3.4 New-synchronisation of the radio channel
•
When you install your keyboard for the fi rst time and no connection
can be established, please synchronise the radio channel between
keyboard and USB receiver again by pressing and holding the keys
(Fn
+ F1) simultaneously. After 2 seconds pairing starts. Pairing can
take several seconds and is fi nished, when the LED above the trackball
is glowing.
Now you can release the keys
the keyboard is ready for use.
Check now the functionality of the keyboard as described under
point 3.3.
In implausible case the keyboard does not work even after new-
synchronisation, you have the following options to solve this
problem:
•
Repeat the procedure of synchronisation as described under 3.4.
Sometimes it is necessary to repeat this routine several times, until the right radio channel is found.
•
In case your USB receiver is attached to an USB hub, you should install it directly on the USB connector
of your notebook or desktop.
•
During the procedure of synchronisation the keyboard should be located close to the USB receiver to
sure, that the immediate environment has no infl uence on the radio transmission (for instance reduction/
interferences due to metal cases, other sources of interferences etc.).
•
Ensure that you use only batteries with full loading capacity. In case of doubt change
the old batteries before next synchronisation against new ones as a precaution.
Low battery capacity is signalised by permanant glowing of the blue LED above
the trackball.
Errors & omissions excepted
All manuals and user guides at all-guides.com
(Fn
+ F1), the LED turns off and
2 x
Pairing LED
make
Low Battery LED
8
Publicité
Table des Matières
