Ewbank 525 Conseils D'utilisation Et D'entretien page 3

Step 3: Slide the base of the handle over the connector arm and
align the button with the hole in the base of the handle.
Step 4: The button will securely snap into the hole of the handle.
Step 5: Screw in the middle section of the sweeper handle. Do not
over tighten.
Step 6: Screw in the top section of the handle (this is has the
largest diameter and one end is plugged).
The sweeper is now ready to use.
Product Disassemble/Storage
Follow the assembly instructions in reverse order;
1. Unscrew the top handle section
2. Unscrew the middle section
3. Finally depress the metal button on the black connector arm
while gently pulling the bottom handle section away from the
sweeper unit.
Product Use
Push and pull the Handy sweeper along the carpet surface to
be cleaned at a steady pace keeping the sweeper unit level to
the floor to remove everyday dust and dirt leaving your carpets
clean and free of debris. Empty your sweeper regularly to
ensure maximum efficiency.
To Empty the Sweeper
Empty your sweeper regularly to ensure maximum efficiency.
To empty, hold the sweeper over a (trash) bin and press the
edges under the body to open the front pan (see picture 1).
Tip the unit forward to clean the front pan. Release pan to
close. Repeat step for the back pan.
Cleaning and Care of the Handy Sweeper
Regularly check the brushes and remove trapped fluff and debris to keep your sweeper operating at
maximum efficiency. The case can be wiped with a damp cloth but do not immerse the unit
in water or other liquids.
3
Step 4 handle secured
Step 5 screw in poles
Step 6 screw in poles
Picture 1