Filling The Boiler - McCulloch MC1230 Mode D'emploi

FILLING THE BOILER

1. Place Handheld Steam Cleaner on a flat, level surface.
2. Make sure On/Off Switch is turned to "Off" and grounded power cord is unplugged from electri-
cal outlet.
If unit has been in use, always use the following safety precautions before
removing the Boiler Cap to add water:
• Allow unit to cool for 20 minutes.
• Press and hold Steam Trigger to release ALL remaining steam.
WARNING: Failure to follow these precautions may result in burns from escaping steam
when the Boiler Cap is removed.
3. Cautiously unscrew and remove Boiler Cap.
4. Drain any water remaining inside Boiler.
NOTE: Boiler should be emptied after each use – this will help minimize mineral build-
up and prevent over-filling.
5. Fill the Fill Cup to maximum fill line (6 oz. / 177 ml.) with water.
NOTE: In order to significantly reduce mineral build-up and prolong the life of your
Handheld Steam Cleaner, use of distilled or de-mineralized water in the unit is highly
recommended. Refer to Page 13 for more information about mineral build-up.
6. Carefully pour water from Fill Cup into Boiler.
WARNING: Caution should always be used when pouring water into the Boiler. Do not
look directly down into fill hole when filling. Keep your free hand and any children or
pets at a safe distance.
7. Replace Boiler Cap, ensuring that it is screwed on tightly to prevent hot steam from escaping
and causing injury.
Using Your Handheld Steam Cleaner
ENGLISH | 11