Installation Steps - Quipon SKY 70 x 50 Instructions De Montage Et Mode D'emploi

Installation steps

Note: Rotational torque of the electrical tool according to mounting screws.
Step 1:
Cut out opening of 700 x 500 mm (R60).
Roof thickness 25–60 mm
702 mm
Note: Consider groove for cable.
Step 3:
Apply sealant to the outer frame groove.
Outer frame
Note: Clean prior to glueing. Do not use any alcohol.
Step 5:
Fix holder with screw.
1. Fix 4 × 4 5 to bolts
2. Secure 4 × 18 to wall
3. Rotational torque 3 Nm
Note: Rotational torque of the
electrical tool according to mounting screws.
Step 7:
Move frame to the
intended position of the
roof window.
Note: Curvature direction of
the lens must match the outer frame.
R60
25–60 mm
502 mm
Adhesive groove
Height: 1.5 mm
Width: 18 mm
Holder
4 × 4 5
4 × 18
LED lens
equipment
Step 2:
Apply sealant / sealing cord around it.
Note: Clean before applying the sealant.
Do not use any alcohol.
Step 4:
Position frame in the assembly opening, remove excess sealant.
Outer frame
rear
Note: Pay attention to the mounting direction and seam in order
to ensure water tightness.
Step 6:
Assembly of the inner frame.
Secure 4 × 12 inner
frame to the wall.
Connect power cable
(12 V + red, 12 V − blue).
Inner
frame
Note: Rotational torque of the
electrical tool according to mounting screws.
Step 8:
Completion
Clean with soap.
front
Seam and
sealant
Cable
4 × 12
6