Trumeter 7110DIN Mode D'emploi page 3

Please note:
Any signal cables connected to this device must not exceed 30 metres in
length. If signal cables are installed that are routed outside the building, it will
be necessary to install additional surge protection devices.
7200DIN Terminal Block Adaptor
Low Speed Count Input
High Speed Count Input
• Plug the adaptor directly into the connector at the rear of the 7110DIN.
• Finger-proof screw connections for wires up to 2.5mm².
7210DIN Isolated High Voltage Input Adaptor
48 - 240V AC/DC
Count Input
5 - 48V AC/DC
Count Input
Count Input Common
• For use with 7110DIN only.
• Plug the adaptor directly into the connector at the rear of the 7110DIN.
• Finger-proof screw connections for wires up to 2.5mm².
• Overvoltage Category II, Pollution Degree 2 (IEC 64)
• Uses 7110DIN Low Speed Count Input.
Mounting
using Built-in Fixing Clip
using 50 x 25 Adaptor
using Screw-Fixed Bezel
6
Common
5
4
6
5
4
48-240V±10%
5-48V
Panel Cutout Size
45.5 x 22.5mm (1.78 x 0.88")
50.3 x 25.3mm (1.98 x 0.99")
<= 48 x 33mm
1
1
2
2
3
4
5
3
7110
1
1
Common
2
3 2
Enable Reset Button
4
5
3
External Reset
7110
58.5K
4K7
Common
Enable Reset Button
External Reset
Maximum Panel
Thickness
7.5mm
7.5mm
----
3