ORTHOSERVICE go up pcl G1044 Mode D'emploi page 14

A D A P T I N G F O R T H E D O C T O R / T E C H N I C I A N
HINGE ADJUSTMENT
1 Press the orange button and at the same time rotate the transparent cover (fig. A).
2 To adjust flexion (fig. B):
• Rotate the opening of the cover to coincide with the flexion stop and remove the pin
• Rotate the cover and the pivot to the hole with the degree of flexion required
(shown on the mechanism) and insert the pin
3 Rotate the cover again (fig. C).
4 To adjust extension (fig. D):
• Rotate the opening of the cover to coincide with the extension stop
and remove the pin
• Rotate the cover and the pivot to the hole with the degree of extension required
(shown on the mechanism) and insert the pin.
5 Rotate the cover until the orange safety button clicks (fig. E).