Replacing Fuse - Dyna-Glo Delux KFA650DGD Guide D'utilisation Et D'instruction

NEVER LEAVE THE HEATER NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING! UNATTENDED WHILE BURNING!

10. REPLACING FUSE

10. REPLACING FUSE
NOTICE : This heater is fuse protected. NOTICE : This heater is fuse protected.
If your heater fails to ignite, DO NOT RETURN YOUR HEATER TO THE If your heater fails to ignite, DO NOT RETURN YOUR HEATER TO THE
STORE. STORE.
Please follow the simple instruction below to inspect and change the fuse. Please follow the simple instruction below to inspect and change the fuse.
WARNING : SHOCK HAZARD
WARNING : SHOCK HAZARD
To prevent personal injury, unplug the power cord before replacing fuse.
To prevent personal injury, unplug the power cord before replacing fuse.
1. Unplug heater.
1. Unplug heater.
2. Remove side cover screws using medium phillips screw driver.
2. Turn Fuse Cover COUNTERCLOCKWISE 45° using a flat blade screwdriver and remove Fuse from
3. Disconnect switch wires from power switch.
Fuse Holder.
4. Remove fuse from fuse holder.(See Figure 21.)
3. Replace Fuse.
5. Replace fuse with enclosed fuse.
WARNING : FIRE HAZARD WARNING : FIRE HAZARD
To avoid fire, Do not substitute with a higher or lower current rating. To avoid fire, Do not substitute with a higher or lower current rating.
6. Replace switch wires to power switch. 4. Turn Fuse Cover CLOCKWISE 45° using a flat blade screwdriver while slightly pushing.
7. Replace side cover.
NOTE : Specified fuse rating : AC 125/8A
NOTE : Specified fuse rating : 250VAC/20A
Screw
Side Cover
Power Switch
PROCEDURE FOR REPLACING FUSE
PROCEDURE FOR REPLACING FUSE
Switch Wire
Figure 16. Replacing Fuse
Figure 16. Replacing Fuse
Fuse
DFA-75T/125C/170CV/210CV Models
Fuse Holder
Fuse
Fuse Holder
14 14
Fuse Holder
Fuse
Fuse Cover
DFA-50 Model