Installation Instructions - Galanz GLF50CWED12 Guide D'utilisation

INSTALLATION INSTRUCTIONS

LOCATION
Two people should be used when moving the
appliance.
Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
Place the appliance on a level floor that is strong
enough to support it when the freezer is fully
loaded.
Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater.
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
Do not use the appliance near water, for
example, in a wet basement or near a sink.
This appliance is intended for indoor household
use only. It is not designed for outside installation,
including anywhere that is not temperature controlled
(garages, porches,vehicles, etc.).
Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
Allow 5 inches of space between the back,
sides and top of the freezer and all adjacent
walls.
This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
IMPORTANT:
Before using the appliance, remove
the rubber plug from the accessory bag and
install it in the interior of the appliance. Do not
run the appliance without the plug installed as
this can cause water leakage and damage to
flooring.
SAVE THESE INSTRUCTIONS
4