EDM Product 07592 Manuel D'instructions page 13

REPLACEMENT OF SHAVING HEADS - REF. 07593
• Change shaving heads every two years for optimum shaving
performance.
• The head makes the shaving performance better.
CHARGE
▶The switch must be off when charging. You cannot shave while
charging.
▶The applicable voltage is 220-240V~ 50Hz.
▶To ensure a long life of the product, you can start shaving once the
battery is fully charged. Likewise, it will not load it again until it has
been fully downloaded.
▶To charge, you must first connect the charging cable to the shaver
and then plug it into the wall socket. Once it has been connected
correctly, a light will come on indicating that it is charging (fig.3
and 4).
▶The shaver needs to be charged for 8 hours to complete the charging
cycle. The time you have for shaving is 45 minutes. After this use the
battery should be fully charged again.
▶Please do not carry the shaver inside the closed bag.
▶If the power cord is damaged, do not use the machine.
DISPOSE OF BATTERY
▶The battery used in this shaver contains material that pollutes the
environment. If you need to discard the shaver, please disassemble
the batteries and take them to the nearest collection center.
▶How to remove the batteries you can follow the instructions in
(fig.18).
▶Before disassembling any part of the machine, such as the battery
for example, it must always be unplugged from the power source. To
check for remaining electricity, turn the shaver on until the motor
stops.
▶Remove the battery (fig.19).
▶After removing the battery, do not connect the shaver to the mains.
Instruction manual
STORAGE
▶Unplug the appliance and store in its box or in a dry place.
▶Never leave it plugged in if you are not using it.
▶Never wrap the cord around the appliance.
▶Never hang unit by cord.
▶If the cord has become tangled, untangle it before use.
ref. 07592
ES
PT
EN
FR