RAB Design FL-LED Serie Instructions D'installation page 2

FL-LED SERIES
INSTALLATION INSTRUCTIONS
SLIP FIT MOUNT

Loosen the angle adjustment screw on swivel portion of the slip fit,
adjust the fixture to a suitable orientation, and then tighten the
screw.

Remove side cover from slip fit bracket to expose wiring access.

Loosen the 4 set screws.

Pull supply wires through slip fit and carefully place the fixture on a
post with a diameter of 2 3/8" (60mm).

Tighten set screws to secure fixture to post.

Connect the wires properly from the wiring access. See Figure 4.

Re-attach side cover.
WIRING INSTRUCTIONS

Check that the line voltage is correct.
o
The standard voltage driver permits operation at 100-277VAC /50/60 Hz.
o
If FL8-LED300 347V is purchased; driver permits operation at 249-528VAC /50/60 Hz.

Connect fixture GROUND (green) wire to power supply GROUND (green) wire.

Connect fixture WHITE wire to power supply NEUTRAL wire.

Connect fixture BLACK wire to power supply LINE wire.
Figure 4: Wiring Instructions
RAB DESIGN LIGHTING INC.
Figure 3: Slip Fit Mount
www.rabdesign.ca 2