FL-LED SERIES
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY
Proper grounding is required to ensure personal safety
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
Do not use this equipment for anything other than its intended purpose.
Servicing this equipment should be performed by qualified service personnel.
Save these instructions for future reference.
INSTALLATION
KNUCKLE MOUNT
The fixture has ½" NPS locking swivel knuckle that is suitable for
mounting with a junction box or into a junction box cover (sold
separately). NOTE: Use appropriate size junction box and/or
junction box cover depending on the size of fixture being mounted.
Pull the wires into the hole of the junction box or cover (not
provided).
Connect the wires properly in the junction box or cover. See
Figure 4.
Mount the fixture to junction box or cover by screwing the
locking swivel knuckle into junction box or cover.
Loosen the screw on swivel portion of the knuckle, adjust the
fixture to a suitable orientation, and then tighten the screw.
YOKE MOUNT
DO NOT remove the yoke from the fixture.
Mount the fixture to the wall with appropriate screws (not
provided).
Pull the wires into the junction box (not provided).
Connect the wires properly in the junction box. See Figure 4.
Loosen the screws on yoke, adjust the fixture to a suitable
orientation, and then tighten the screws.
RAB DESIGN LIGHTING INC.
READ, UNDERSTAND
before installing the equipment.
Figure 1: Knuckle Mount
Figure 2: Yoke Mount
www.rabdesign.ca
FOLLOW
, and
these instructions
1