Technical Data - DAY 73439 Manuel D'instructions

SOAP DISPENSER
Introduction
To get the most out of your new soap dispenser, please
read through these instructions before use. Please also
save the instructions in case you need to refer to them at
a later date.

Technical data

Power supply:
Capacity:
With infrared sensor and foam function
Class III: Protection against electric shock is
III
achieved because the item is only supplied
with extra-low voltage and the item itself
does not generate a higher voltage than
extra-low voltage.
10
4×1.5 V AA batteries
(not included)
300 ml
Use
Carefully unpack the soap dispenser.
Open the battery cover on the base of the soap dispenser
by turning it anticlockwise and insert 4 x 1.5 V AA
batteries. Insert the batteries in the battery compartment
as indicated.
Replace the batter cover so that the arrows are lined up.
Turn the battery cover clockwise until it locks into place.
Stand the soap dispenser upright and remove the silicon
plug from the refi lling opening.
Foam is produced with 1/3 soap and 2/3 water.
Do not fi ll the container with soaps that contain solid
particles, as these may damage the soap dispenser.
Replace the upper section again.
Switch the soap dispenser on using the on/off button at
the top.
The soap dispenser is now ready for use.
When you want soap, simply place your hands under the
soap dispenser's nozzle and wait until the soap foam is
dispensed.