TypeS TERRA PRO Directives D'utilisation Et D'entretien page 8

4) PAIRING
Pairing Button
• The unit is ready to use without additional pairing. However the Switch Controller can control
additional Type S Light Bars via pairing. One Switch Controller can connect up to 4 Light Bars.
• To pair, press the pair button on the Hub Controller once. (Fig.1) The unit goes into pairing mode for
30 seconds. Plug in the Switch Controller into a 12V car socket, then press and hold the pair button
for 3 seconds. (Fig.2) It will pair with the Hub Controller within 5 seconds.
• Flip the toggle switch on/off to check if the connection is successful. Repeat above steps to pair each
additional Type S Light Bar to the same Switch Controller.
5) PLUG IN SWITCH CONTROLLER
8
Fig.1
• Plug the Switch Controller into any 12V car socket.
• Flip the toggle switch to turn the Light Bar on/off. The blue LED
indicator will be flashing slowly, indicating it's on and paired.
• Light Bar will be turned off automatically when the engine shuts off.
Warning: Some vehicles provide constant power to the 12V outlet.
Please remember to unplug the Switch Controller when not in use to
avoid draining of the vehicle battery.
Pairing
Button
Fig.2