TypeS TERRA PRO Directives D'utilisation Et D'entretien page 7

2) CONNECT THE LIGHT TO THE HUB CONTROLLER
- Connect the Light Bar cable with the Hub Controller cable. Make sure the
connectors are securely fastened and route cables away from engine. The
connectors are directional, make sure to connect to the correct position and
fasten each end of the cap.
- Position the Hub Controller away from the car engine. Make sure to avoid
placing the Hub Controller or cables near any extremely HOT location or
next to the car's engine. Use 3M™ double sided tape or zip ties to secure
the Hub Controller to any flat surface if needed. The best location for the
Hub Controller will be inside the front grill if possible.
3) INSTALLING THE HUB CONTROLLER:
• For use with 12V power only
• Hub Controller hardwire cables are color-coded,
(+) and BLACK for NEGATIVE (-).
RED
- Connect the
illustrated. The POSITIVE battery post will be slightly larger than
the NEGATIVE post, and will be marked with a PLUS (+) sign.
There may also be a
battery post.
- Connect the BLACK cable to the NEGATIVE (-) battery clamp
as illustrated. The NEGATIVE will be marked with a MINUS (-)
sign. There may also be a BLACK plastic protective cover over
the negative battery post.
NOTE: After connecting the Hub Controller to the car battery, the
Blue LED indicator will flash. If the LED indicator does not flash once
connected, please check your power connections.
WARNING: DO NOT mix up the cables or allow the
metal ends to touch together because this may damage
the battery, charging system and/or electronics on a
vehicle. When installing, please make sure your engine
is not running.
cable to the POSITIVE (+) battery clamp as
RED protective cover over the positive
RED
for POSITIVE
Power Indicator
7