Description Of The Unit; Operation; Handling - Zanotti RDV Série Notice De Mode D'emploi Et D'entretien

3

DESCRIPTION OF THE UNIT

The RDV series includes air-cooled or water-cooled (optional)units
principle. They consist of:
4

OPERATION

RDV single blocks are compression units where cold is produced by vaporizing a liquid refrigerant (HFC type)
at low pressure in a heat exchanger (evaporator). The resulting vapour is brought again into the liquid state by
mechanical compression at a higher pressure, followed by cooling in another heat exchanger (condenser). The
compressor is hermetic, with reciprocating motion, supplied with single-phase or three-phase power.
5

HANDLING

The unit can be handled by lifting and transport means.
W AR NI NG
M ake sure that no one is in transit in the operating area of the lifting/ transport m eans
to prevent any possible accidents to people.
I f the unit is in a w ooden case or crate, sling the packing properly before handling
it.
2
1
1. a condensing unit placed outside the cold room;
2. an evaporator placed inside the coldroom
3. a wall-mounted remote control panel.
built on the basis of the single-block
21
3