NSS OUTLAW BV Traduction Des Instructions Originales page 3

OUTLAW BV - DRY VACUUM
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
conductor can result in a risk of electric shock. Check with a qualified
electrician or service person if you are in doubt as to whether the outlet
is properly grounded. Do not modify the plug provided with the
machine. If outlet is not suitable for safe use; have a properly grounded
outlet installed by a qualified electrician.
Always use a properly grounded 3-wire extension cord, which has
male and female plugs. If 25 foot extension cords are used, the
electrical carrying capacity should be no less than 16-3 SJ OR SJT.
50-foot extension cords no less than 14-3 SJ OR SJT.
GROUNDING INSTRUCTIONS
This machine shall be grounded while in use to protect the operator from electric shock. The machine is provided
with a three-conductor cord and a three-contact grounding type attachment plug. The plug must be plugged into an
appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. The
green conductor in the cord is the ground wire. Never connect this wire to other than the grounding pin of the
attachment plug.
Check nameplate on the machine to be sure voltage and cycle stated is the same as the electrical outlet. Do not
attempt to plug a 120-volt machine into a 240-volt outlet or a 240-volt machine into a 120-volt outlet. If a properly
grounded receptacle as shown in Figure A. is not available, an adapter may be installed as shown in Figure B. if the
outlet box that houses the receptacle is grounded. Be sure to fasten the grounding tab (the green colored rigid ear,
lug or the like extending from the adapter) with a metal faceplate screw.
If the body of the vacuum has a label of an airplane on it, the unit is for use on airplanes at 120 volt, 400 HZ. DO
NOT use standard 120 voltage on airplanes, damage to the unit, and injury to the operator will occur.
NOTE: In Canada, the use of a temporary adaptor may not be permitted by Canadian electrical code.
ALL REPAIR SERVICE MUST BE PERFORMED BY AN NSS AUTHORIZED DISTRIBUTOR/
SERVICE STATION USING ONLY NSS ORIGINAL EQUIPMENT PARTS.
OPERATION MANUAL
GROUNDING OF ELECTRICAL EQUIPMENT
Improper connection of the equipment–grounding
SAVE THESE INSTRUCTIONS