Publicité
Les langues disponibles
Les langues disponibles
EN
Before performing a leak test, be sure that no sparks can occur
and you are in a spacious outdoor area. Connect the propane gas
tank to the regulator and turn the valve on the unit to the "off"
position. Brush a soap and water mixture on all connections. Turn
the gas supply on; if bubbles occur on any connection there may
be a leak. If you smell gas or a leak is discovered turn the gas
valve off, disconnect propane gas tank and do not use the
appliance until the leak is repaired.
Do not use the heating unit without inspecting the gas hose. If
there are signs of wear or abrasion you must replace the hose (if
applicable). Pumice stones/lava rocks/LavaGlass® could pop up
and strike somebody's face during the process of lighting this unit;
stand away from the unit for the first 20 minutes after igniting.
Flame height should be a yellow/blue color between 2 - 10
inches(5.08 - 25.4 cm) in height.
Wait 50 minutes after extinguishing flame prior to placing a lid (if
applicable) or protective cover on heating item.
To Light
1. Make sure the control knob is in the "OFF" position.
2. slowly open the valve on the propane gas tank by turning the
knob counterclockwise.
3. Push and hold the electronic igniter to create sparks within the
electrode, continue to hold.
4. Push in the control knob and turn to the "low" position. Keep
holding the control knob to allow gags to flow for 45 seconds.
5. If ignition doesn't occur within a few seconds, release the
control knob and rotate to the "OFF" position. Wait for 5 minutes
for gas to clear and then repeat the above lighting instructions.
14
Publicité
