Hinkley 930005 Mode D'emploi page 3

INSTALLING THE LIGHT KIT
WARNING: Be sure electricity is turned off at the main power box before wiring.
Remove and discard the center plug from the switch housing. Attach
1
the reflective plate and light kit to the switch housing by feeding the
light fixture wires (black and white) through the hole in the center of
the switch housing, then screw the light fixture stem onto the switch
housing. (Fig. 1)
Thread the nut & lock washer onto the light fixture stem inside the
2
switch housing making sure the light fixture is secure, preventing
movement after installation. (Fig. 1)
Locate the white and blue wires inside the switch housing labeled
3
FOR LIGHT.
Attach the wires from the light kit to the wires inside the switch
4
housing by pushing the polarized connections together. (Fig. 1)
- White wire to White wire
- Black wire to Black (Blue) wire
Raise and hold the light kit assembly close to the switch housing hub
of the ceiling fan. Push the square wire connectors together. (Fig. 2)
5
NOTE: The square connectors are color coded. Match the color
coded sides of each plug and push. They will attach ONLY when
matched correctly.
Carefully push all wires back into the switch housing, then install the
6
light kit assembly onto the switch housing hub with 3 screws
provided. Be sure to tighten all screws. (Fig. 2)
7
Install two 9 watt LED bulbs (included).
Remove the decorative nut, glass cap and the metal nut from the
8
light kit.
While holding the glass shade, slip the pull chain from the switch
9
housing into the outside hole in the glass shade. Feed the pull chain
from the light kit stem through the eyelet on the glass shade.
Place the glass shade over the light kit stem. Secure the glass shade
10
with the metal nut (rubber side on the top). Fit the glass cap onto the
light kit stem and then slip the pull chain through the hole on the side
of the glass cap.
Feed the pull chain from the light kit stem through the glass cap and
11
the decorative nut, and then thread the decorative nut on securely.
Do not overtighten.
Nut
Lock washer
Center
plug
Reflective
plate
Fig. 1
Keyhole Slot (x3)
Connector (receptacle)
Bulbs
Glass
Shade
Metal Nut
Glass Cap
Decorative Nut
Fig. 2
©2019 Hinkley Lighting, Inc. | hinkley.com |
Switch
housing
Light kit
Switch Housing Hub
(bottom of motor)
Connector (plug)
with Side Buckle
Light Kit
Assembly
Pull
Chain
03