Rainfresh RS1 Instructions Pour L'installation

WATER FILTER REMOVAL
AND INSTALLATION INSTRUCTIONS
MODEL RS1
INSTRUCTIONS
1. Locate filter inside the refrigerator. First slowly
turn the cartridge ¼ turn to the left and remove.
2. Remove all packaging, apply date label if required
as a reminder to replace the filter within
6 months and remove the protective sticker
from the top.
3. Insert filter into refrigerator and turn 1/4 to
1/2 turn to the right - label in front.
Do not over-tighten.
4. Run water for 5 minutes through the dispenser to
flush the filter. Reset the light if needed by holding
down the ice type and child lock buttons
for 3 seconds.
5. Check the filter for any leaks or any sign
of moisture. Your new filter is ready for use
1.
3.
Protect filter cartridge from freezing.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system.
Cartridge Life : 300 US Gal (1,136L) or 6 months
Tested and cer fied by The Water Quality Associa on
to NSF/ANSI 53*, NSF/ANSI 42* and to CSA B483.1
* See performance data sheet for details
Envirogard Products Limited
446 Major Mackenzie Dr E, Richmond Hill, ON, L4C1J2, CANADA
Help Line : 1800 667 8072
www.rainfresh.ca
©
Copyright . Envirogard Products Limited . 2016 . All rights reserved
2.
4.
Toronto & Area : (905) 884 9388
07/2016 . 803146