Technical Data; Preparation - Max 37496 Manuel D'instructions

FOLDABLE LED WORK LIGHT
Introduction
To get the most out of your new foldable
LED work light, please read through these
instructions before use.
Please also save the instructions in case you
need to refer to them at a later date.

Technical data

Voltage:
Power supply:
Light output, 1 light on:
Light output, 2 lights on:
Operating time with 2 lights on:
The operating time has been tested using
2,900 mAh alkaline batteries (Nor-tec).
Can be rotated 180°

Preparation

Remove the battery covers from the rear of
the lights.
Insert 2 x 1.5 V AA batteries into each light.
Check that the batteries are correctly � tted.
Replace the battery covers.
Use
Unfold the LED work light to the required
position.
Press the on/off button on the side of the
LED work light one or more times to switch
on one or both lights, or to switch them off .
10
2×3 V
2×2 1.5 V AA batteries
(not included)
220 lumen
400 lumen
3 hours