Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ADJUST THE AUXILIARY HANDLE
1
Press the auxiliary handle locking knob
3
to rotate the handle
2
to a comforta-
ble position. Release the locking knob.
REPLACE THE SPOOL
1
Press both catches together and remove
the cover. Replace the spool 9 or wind
3 m of 1.65 mm ø cutting line around the
spool in direction of the arrows. Guide
the end of the line outwards.
CHARGE BATTERY (NOT INCLUDED)
1
Plug the charger (not included) into a
suitable wall socket.
Caution! Only use the battery
charger specified in technical data
to charge the battery.
ATTACH BATTERY
1
Slide the charged battery
11
battery slot on the grass trimmer until
it clicks into place.
Caution! Only use the intended bat-
tery with the machine.
SWITCHING ON/ OFF
1
On: Press and hold the release switch
14
and the on/ off switch 13.
Off: Release the on/ off switch.
Warning! The line continues run-
ning for a short time after switching
off the grass trimmer.
138
EN
ADJUST THE HEIGHT
2
Unscrew the height adjustment locking
collar
5
clockwise to adjust the height
of the tube. Tighten the height adjust-
ment locking collar counter-clockwise
to lock the height.
2
Reattach the cover and pull on the line
end to release line from the spool.
Note: The knife integrated in the safety
guard
10
trims the cutting line auto-
matically to the required length.
2
Slide the battery
11
onto the charger
and check its LEDs:
Red: Charging
Green: Battery is fully charged
Flashing Red: Battery is defective
Flashing Green: Battery is too hot/ cold
RELEASE BATTERY
into the
2
Press the battery release switch
pull out the battery 11.
1
2. 2.
1
1
12
and
1
1
1. 1.
2
1. 1.
2
2
2
2. 2.
1. 1.
2. 2.
2. 2.
1. 1.
1. 1.
2. 2.
EN
139
Publicité
Table des Matières
Dépannage
