brondell PureSpa PS-65 Mode D'emploi page 6

INSTALLATION (cont.)
BEFORE INSTALLATION
Check Water Supply Line
Check the water supply line that connects the toilet tank fill valve to the water
shutoff valve at the wall . If it is a rigid pipe, you will need to purchase a flexible
water supply hose to replace it before installing the PureSpa . The length of the
hose may vary, and the top connection size should be 7/8" Ballcock to connect to
the T-valve that you will install under the toilet tank, and the bottom connection will
vary (most common are 3/8" and 1/2" female compression) .
INSTALLING THE BIDET ATTACHMENT
1 . Remove existing toilet seat
a . Lift hinge covers and use flathead or Phillips
head screwdriver to remove the mounting
bolts . Alternatively, you may need to loosen
mounting bolts underneath the seat .
b . Remove the toilet seat and set the seat,
mounting bolts and hardware aside .
2 . Turn off water supply valve and flush toilet
a . Turn off water supply at the wall to stop flow
of water .
b . Flush toilet and hold down handle to
completely empty toilet tank .
c . Disconnect water supply hose from the fill
valve under the toilet tank .
5
Step 1b
Step 2c