Setting The Parameters: - Faster KS-20 SPEED Manuel D'utilisateur

2.1. To access the parameter setting mode
When the contact key is turned on, press the button «M» to enter into the setting mode. In this mode (See
Figure 16), you will be able to set the desired parameters.
If you press the button «M» for a long time (More than 3 seconds), the current value of the chosen setting is
displayed. You can then modify this value and then press the button «M» to confirm the new choice.
2.2. To exit the parameter setting mode
If you turn off the vehicle's power using the contact key, or wait 10 seconds without taking any action, you will
automatically exit the setting mode and enter in the regular operating mode.

2.3. Setting the parameters:

P00 - Display backlight adjustment
Press and hold the button «M» (More than 3 seconds) until the brightness indicator flashes, then press
the button «M» momentarily to change the value for the display brightness. There are three levels (0,1,2),
with level 2 being the brightest.
P01 - Set Voltage
Press the button «M» (More than 3 seconds) until the voltage value flashes, then press the button «M»
momentarily to change the kick scooter voltage value. The current model offers two choices, 36 or 48
volts.
P02 - Set the diameter of the wheel
Press and hold the button «M» (More than 3 seconds) until the wheel diameter value flashes, then press
the button «M» momentarily to change the current value from the following choices (In inches): 8, 10, 12,
14, 16, 18, 20, 22, 24, 26, 28, 29.
P03 - Set the speed coefficient
Press and hold the button «M» (More than 3 seconds) until the speed coefficient value flashes, then
briefly press the button «M» to change it to a value between 0.9 and 1.1 (Which corresponds to a value
between 90 and 110 on the screen).
9