Heath Zenith SL-6148 Manuel D'instructions page 3

WARNING: Disconnect chime unit from power source before
opening code access door. Close door and replace screw before
reconnecting to power.
Your wireless chime has different selectable tunes: Ding (one note), Ding-Dong
(two note), or Westminster (eight note) (Available on selected chimes). The
factory setting is for the Ding-Dong tune (or Westminster, when available). This
tune can be changed by following the instructions below.
• Ding (one note tune)
Inside Push Button: Add a jumper to location 8.
• Ding-Dong (two note tune)
Inside Push Button: Remove jumper from location 8.
Chime: Remove jumper from location 8.
• Westminster (Eight note tune) (Available on selected chimes)
Inside Push Button: Remove jumper from location 8.
Chime: Add a jumper to location 8.
Note: All models have both front and back door tune capabilities.We recommend
the back door use the Ding tune and the front door use the Ding-Dong tune
(or Westminster tune, available on selected chimes). Models that include two
push buttons will come factory set for front and back doors. Decals on the rear
of the push button will indicate its setting.
Remove screw to
open access door
Back of Chime
Helpful Videos – www.hzsupport.com
Tune Settings
Tune Setting
(Not used on all
models)
Figure 4
Inside Push
Button
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
Helpful Answers – 1-800-858-8501
3
Tune Setting