MaxLite T5C-BBU Serie Mode D'emploi page 2

Operating Instructions
MaxLite Battery Backup for Type C Linears
®
Operation
AC Operation:
An un-switched AC power source of 100V AC to 277V AC is required. This device is for use in fixtures listed for dry and
damp locations. Do not use this emergency driver with accessory equipment other than recommended by manufacturer.
Do not use this emergency driver for other than intended use. Failure to follow this may cause an unsafe condition. Serv-
icing should only be performed by qualified service personnel. Equipment should be mounted in locations and at heights
where it will not readily be subjected to tampering by unauthorized personnel.
Emergency operation:
When the AC power goes out, the emergency driver detects the AC power outage and automatically switches to the
working emergency mode. When the green LED off, the AC power is restored. The emergency driver goes back to AC
power and starts re-charging. The green LED light turns on.
General Wiring Diagram
N
L
White/Black
1. DO NOT MATE CONNECTOR UNTIL INSTALLATION IS COMPLETE AND AC POWER IS SUPPLIED.
2. TEST ACCESSORY LEADS-OBSERVE PROPER POLARITY WIRING.
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
WHITE
BLACK
Emergency Controller
WHITE
DRIVER
BLACK
Yellow
Violet
Brown
White
White
Red
Red
Blue
T5C-BBU Series
TEST BUTTON
Connector
LED lamp
Page: 2
REV: 07/06/20