MaxLite T5C-BBU Serie Mode D'emploi

Operating Instructions
MaxLite Battery Backup for Type C Linears
®
General Safety Information
• Risk of fire or electric shock.Luminaire wiring and electrical parts may be
damaged when drilling for installation of LED Emergency Backup. Check for
enclosed wiring and components.
• Risk of fire or electric shock.This LED Emergency Backup installation
requires knowledge of luminaire electrical systems.If not qualified,do not
attempt installation.Contact a qualified electrician.
• Before installing make certain the, AC power to the fixture is off.
• The electrical rating of this product is 100-277Vac.Installer must confirm that
there is 100-277Vac to the fixture before installation.
• To prevent electrical shock only mate unit connector after installation is complete
and before the AC power to the fixture is back on.
• Do not use in outdoor.
• This LED Emergency Backup unit requires an un switched AC power source of
100-277Vac 50/60Hz The AC driver must be on the same branch circuit as the
LED Emergency Backup unit.
• Do not let power supply cords touch hot surfaces.
• Do not mount near gas or electric heaters.
• Do not connect battery pack connector until all other wiring is complete and AC power is on.
• The emergency LED driver is for use with grounded, UL listed LED luminaires, shall be enclosed by the LED
luminaire and bonded to the grounding of LED luminaire.
• Verify that all replacement lamp types marked on the installed luminaire are also identified as suitable for
use with this emergency battery pack.
• The battery pack is fied by the screw and the indicator lamp is attached to the shell of the luminaire by 3M tape
• Equipment should be mounted in locations and at heights where it is not be subjected to tampering by
unauthorized personnel.
• The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe condition.
• Do not use this equipment for other than its intended use.
• Use with grounded, UL Listed, dry or damp location rated fixtures.
Specifications
Universal Input Voltage: 120-277Vac, 50/60Hz
AC Input Power Rating: 5.0W max.
Output Power: 2W
Full Warranty: 5 Years
Battery: LiFePO4
Charging Time: 24 Hours
Dimensions: 9.5''x0.32''x1.22''
These emergency packs have been evaluated to and found compliant to UL 924. The emergency pack assembly is accepted as a
component of a luminary where the suitability of the combination shall be determined by UL or Authorities Having Jurisdiction. The
as-installed performance of the system must meet or exceed all Federal, State, and Local code requirements.
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
AC Input Current: 100mA max.
Output Current and Voltage: 100-250mA 20-50Vdc
Emergency Time: 1.5H
Test Switch Indicator Light: Illuminated Test Switch, Indicator Light
Battery Charging Current: 140-165mA
Temperature Rating (Ambient):
Storage Temperature: -20°C to 80°C (-4°F to 176°F)
(241mmx8.1mmx31mm)
T5C-BBU Series
Picture is for illustration purposes only.
Your model may vary.
T5C-BBU Series
LiFePO4 0°C to 50°C (32°F to 122°F)
Page: 1
REV: 07/06/20