Sicame SM-CI MALICO PST Notice De Mise En Œuvre page 4

NOTICE DE MISE EN ŒUVRE ET D'INSTALLATION
INSTRUCTIONS FOR INSTALLATION
1
Position the hole of the clamp body
in the hook by directing the end of
the upper flat towards the pigtail
screw.
1 Take the sleeve and insert the cable
deep into the groove.
4 Fit the fusible screw in its housing
and initiate hand-tightening by
lowering the head of the screw
towards the bottom of the oblong
hole and ensuring the correct
alignment of the screw in the thread.
Cable disassembly and replacement:
1. Loosen the screw with a 17mm hex wrench.
2. Remove the sleeve and the cable.
3. If a new cable assembly is planned, follow the previous procedure but, to tighten the screw, use a 17mm hexagonal wrench
with a tightening torque of 12 Nm ± 1.
SM-CI - 450 rue Jacquard - Z.I. La Madeleine - BP 3127 - 27031 EVREUX Cedex - France
Tél. : +33 (0)2 32 23 35 60 – www.malico-telecom.com - www.sm-ci.com - infos@sm-ci.com
Pince de suspension
Suspension clamp
PST
Assembly of the clamp body on a pigtail bolt type BQC 12 50
Assembly of the sleeve and the cable
2 Remove the fuse screw from the
body to leave room for the sleeve.
5 Pull the cable to adjust the sag. If
the cable needs more restraint,
tighten the screw more.
MO10090418
14/09/22 - B
S. ESMAN
4/4
3 Position the sleeve in the clamp
body by pressing it firmly all the
way.
6 Finish tightening the screw
preferably with a 13mm hex ratchet
ring spanner until the shear head
breaks.