AMG Redonda 20 Mode D'emploi page 52

Maintenance and cleaning mod. 20-24-28-32
CLEANING BY THE TECHNICAL
Compartment ventilation flue gas cleaning
Remove the fixing screws and remove the smoke fan for cleaning of the same. Perform the task with
the greatest care not to bend the fan blades.
Clean flue
Clean the flue system especially near the fittings to "T", curves and any horizontal sections. Is necessary
to check and remove any deposit of ash and soot before the same clogging the passage of smoke.
Cleaning the exchanger
Lift the upper door that covers the tube by
unscrewing the screws. Pull out the 16 soft brush
and wipe with a clean 16 exchanger tubes.
Perform cleaning after removing the springs
inserted in each pipe. The operation is simple by
removing the springs from the horizontal pin to
which they are attached.
To do this, the horizontal pin can be pulled through
a hole in the wall of the Thermostove body.
Now the upper section to the heat exchanger
is free from any encumbrance so as to allow a
perfect cleaning. Once a year is also recommended
to clean the upper compartment of the exchanger.
To make a proper cleaning is recommended to
suck the ash, remove all horizontal joints with a
screwdriver, then again suck the ash.
The transaction can be completed with a screwdriver
by removing the wall of the Thermostove and
removing all horizontal joints.
52