Electrical Connections; Wiring Schematic - Suncourt Centrax TF104 Instructions D'installation

FIGURE 1: MOUNTING BRACKETS
NOTE: Rubber washer must be placed
between bracket and housing.
FIGURE 2: MOUNTING

ELECTRICAL CONNECTIONS

1. Remove the screws from the electrical box cover plate.
2. Install the appropriate size strain relief or conduit fitting in knock-out provided on the side of the electrical box.
Run the incoming power through the strain relief or conduit and knockout.
3. Connect the incoming power according to the wiring diagram. (Refer to Figure 3)
4. Secure the strain relief and reattach the electrical box cover. The fan is now ready for use.
FIGURE 3: WIRING DIAGRAM
Wiring diagram does not apply to units with installed cord.
CUSTOMER
CONNECTIONS
120VAC, 60Hz
FAN INTAKE
WHITE (NEUTRAL)
BLACK (LINE)
GREEN OR
GREEN YELLOW
(GROUND)
WHITE (NEUTRAL)
CAPACITOR
BLACK
WIRE NUT
BLACK (LINE)
GREEN OR GREEN YELLOW
(GROUND)

WIRING SCHEMATIC

WHITE (NEUTRAL)
BLACK (LINE)
GREEN OR
GREEN YELLOW
(GROUND)
BROWN
MOTOR
120VAC, 60Hz, TP
MOTOR
120VAC, 60Hz, TP
FAN EXHAUST
PRE-WIRED FACTORY
CONNECTIONS